Liam Baugh

• Used hand and power tools and diagnostic equipment to complete various aspects of jobs.
• Followed direction of senior electrical professionals to complete safe, efficient and accurate work.
• Maintained clean, neat and organised work areas.
• Shadowed qualified electricians to understand electrical installation, repair and maintenance tasks.
• Assisted with electrical installations, including lighting and smoke detectors.
• Measured and cut required supplies such as wire and conduit.
• Collaborated with team members to accomplish projects.
• Prepared wiring, fixtures and fittings to exact project requirements.
• Measured and cut out installation points, adhering to wiring plans and diagrams.
• Installed, examined and repaired electrical wiring systems in different settings.
• Tested electrical installations for performance and functionality.
• Connected wires and cables to terminal points and connectors.
• Documented completed work to company standards.
• Demonstrated knowledge of safety protocols and industry best practices.
• Identified electrical faults quickly, enabling prompt repair.
• Fitted high-performing electrical wiring systems to exact specifications.
• Set up electrical switchboards to exact system specifications.
• Promoted commitment to safety standards and HSE requirements.

During my time at this company i was able to work on many different projects. i worked in Holland for 4 months on a frozen food factory pulling in wires for our systems, putting in the correct containment within the factory, glanding cables into the correct junction boxes, connected the junction boxes up using the correct specification demonstrated through the drawings, glanding and termination of cables within our control panel. within this job i also worked along side the dutch commissioner to fix any problems on the system during the testing phase.

I have worked on Tank systems such as United Molasses and Univar. From completion of the control panels within out workshop to following them onsite and connecting them up.

i Have worked on Control Systems for Juniper-Liverpool to create an efficient control panel to go with their rigs to wash airplanes.

my most recent project was working on a system to make it more effective on a site called IKO, here we put all the containment up, pulled cables in, tied cables in using the correct zip-ties, glanded the cables within out RIO panels and connected each end of the cable into the correct place using the wiring diagrams.